A) Daily inspection: Daily protective maintenance should be carried out after eight operating hours. After the end of the day, turn off the power of the computer and the machine, vacuum the dust on the back of the machine and wipe the dust on the surface of the device with a white cloth. If the environment is poor, maintenance should be performed more frequently. Note: Do not use organic solvents to wipe, as this may damage the surface of the equipment.
B) Weekly inspection: Weekly protective maintenance should be carried out after every 40 operating hours. If the environment is poor, the cycle should be shortened. Note: The lubricants and lubricants used must be of good quality. Otherwise, the surface friction of the screw or the guide rail is increased, thereby shortening the service life of the screw rod and affecting the accurate positioning of the machine. WARNING: Do not use phosphoric acid and oxidized hydrocarbon synthesizers in the lubrication system or in the gas path of the factory. Check the equipment in the lubrication unit. If necessary, add 100CKR lubricant.
C) Monthly inspection: monthly protective maintenance should be carried out every 200 operating hours. If the environment is poor, the cycle should be shortened. Check the flow of the pneumatic oil through the observation hole. The flow rate should be divided into 3-5 drops in five minutes. The groove screw on the top of the lubrication device can be turned to the rear of the funnel to adjust the flow rate. At the beginning, it should be adjusted to 1/4. 1/2 open, the counterclockwise screw will increase/decrease the oil flow rate.